HP configs

I'm assuming you're using some Cisco IOS version.

The equivalent to the Cisco IOS command "Show" is the HP comware command "Display".

so

1: show version ~ display version

2: show running-config ~ display current-configuration

3: show ip interface brief ~ display ip interface brief

4: show interfaces trunk:

There is no direct "translation" a comware command here. But "display interface brief" and "display port trunk" might both create the output you're looking for.

5: show cdp neighbors

Well the HP series run lldp and not cdp. Depending on what output you expect, you might want to run a "display lldp neighbor-information list"

6: show vlan

I havent found a command that does exactly what Cisco IOS "show vlan" does, however you can do : "display current-configuration configuration  - and the output you look for will be part of that, or you can do :

vlan 1

display this

which is 2 commands.

7: show ip protocols :

there is no one command for this, but try.

 display ip routing-table protocol [bgp,direct,isis,ispf, rip, static] verbose

8: show ip route ~ display ip routing-table (verbose)

where verbose is optional.




HP			Cisco

enable
quit			exit
undo		no
display		show
reboot		reload
header		banner
reset		clear
acl			access-list
port			switchport
stp			spanning-tree
snmp-agent	snmp-server
user-interface	line
return		end
sysname		hostname
save			write
delet		eerase
info-center	logging